Strength Training Guidelines by Matt Russ

Chest 4-6 exercises

Back 4-6

Triceps2-3

Biceps1-2

Shoulders2-3

Women

Chest3-4 exercises

Back3-4

Triceps1-2

Biceps1-2

Shoulders2-3

Repetitions per exercise: When selecting the number of repetitions per set

it is important to note that the intensity level. For males wanting to build

mass each set should be performed to "failure with form." This simply means as many repetitions you can do to momentary muscle failure while maintaining proper form. Women may not need to train this intensely and should concentrate on getting a good muscle "burn" without complete failure.

Men: The following repetition scheme is based on protein breakdownor "tearing down" of the muscle in order to build it back up and make it stronger. More reps will not stress the muscle enough and too few will stress it too much and may promote injury.

Repetitions per set (cont.)

Men

2 sets3 sets4 sets

- 10 reps- 12-12

- 6 reps- 8-10

- 6- 8

- 4

Women: Women do not need to "pyramid" like men and may perform the

same number of repetitions per set.

1 set2 sets3 sets

- 16 reps- 12 to 20- 12 to 20

Weight: I often tell my clients that the amount of weight they are lifting is not relevant. This is for several reasons. Because you are changing your routine to keep your body "off guard" you may not be able to lift the same amount as your last work out. For example, if you started out fresh with a dumbbell press last week and lifted to failure with 4 repetitions of 60 #'s, and this week you did two sets of push-ups prior to performing the same exercise, you may only be able to lift 45 #'s for 4 reps. If you are lifting each set to failure you have reached the maximum load your muscle can take for X number of reps, and you can not go beyond that limit. This is your

primary objective, not to increase the amount of resistance. The amount you are able to lift on any given day is based on factors such as diet, rest between sets, prior activities, and stress. Do not get discouraged by the amount you are lifting. Concentrate on using proper form to muscle failure. Your first set should be used to warm up the joint and muscle and should be a comfortable weight. Use your first set to judge the progressive weight of your next sets. If your warm up set was very easy, and your goal is to lift 8 reps to failure on your next, you will know to adjust the weight accordingly. Once you get comfortable with your bodies abilities, selecting resistance will become intuitive. "Pyramiding" simply means matching the resistance to the number of repetitions. An example of pyramiding for 3 sets of 12-10-6 repetitions would be using 20 #'s on your first set, 25#'s on the second, and 30#'s on the third.

III. Advanced Training Techniques

There are several ways to stimulate muscle growth and endurance without

necessarily increasing resistance. These techniques are used to keep your body

adjusting and avoiding plateaus. It is important to note that each technique should

be used sparingly because it might be too intense to use on a regular basis, and may not give a muscle group adequate time to recover and repair.

It you are beginning to strength train I would avoid most of these techniques until you have adequate tendon, joint, and ligament strength.

1. Drop Set: Start with 1 warm up set. Select the amount of resistance you would normally use on your last set to failure. Lift to failure, drop 10% resistance, and lift to

failure and drop another 20%, lift to failure, drop 50% and do as many reps as you

can. You can do a drop set with four, three, two, or a single drop in weight.

2. Compound Set: A compound set is performing two exercises for the same body part back to back with no rest in-between. Ex. bench press / push up; preacher curl / hammer curl; triceps kickback / bench dip. Compound sets will quickly bring a muscle group to failure therefore it is unnecessary to perform multiple exercises.

3. Super Set: A super set works opposing muscle groups back to back with no

rest in-between sets. An example would be performing a bicep curl and triceps extension, leg extension (quadriceps) and leg curl (hamstrings), seated row (back) and chest press. Super sets are great for minimizing the amount of time needed to

workout.

4. Partials: Normally an exercise works a joint through a complete range of motion. Partials are used when the muscles are too fatigued to do a complete range of motion and attempt to squeeze the last bit of strength out of them. Once you have reached failure in the full range, complete several more reps to failure using the last half of the range of motion.

5. Negatives: You can accomplish just as much in the lowering or negative phase of an exercise as the positive or exertion phase. The negative phase for a bicep curl would be lowering the weight to the starting position. For biomechanical reason your muscles can accommodate 20% more resistance in this phase therefore increased weight and usually a partner are needed. Negatives increase the load on tendons, joints, and ligaments therefore I use negatives on only my most stable clients who have been strength training for some time. You can perform a form of negative resistance by taking as much as ten seconds to lower the weight. This is much safer and easier on the joint. Note that negatives are used for mass building not endurance.

6. Super Slow: When you work out you attempt to recruit as many of the fibers in a muscle as possible; at failure you are achieving maximum recruitment. The super slow method is an effective way to recruit muscle fiber without using a lot of weight. Simply take ten seconds to perform both the positive and negative phases of an exercise. You will want to use lower weight. The first few reps will be easy but the muscle will quickly begin to burn. Because the super slow method is tedious I do not recommend its' use in an entire workout. I would use this method sparingly in one set per body part.

7. Rep Sets: Your muscles are composed of mix different fibers, some are used for short bursts of power others for endurance. Generally speaking the power fibers hypertrophy, or get bigger than the endurance fibers, but the endurance fibers still can be worked. A rep set works a muscle group using low weight and high repetitions versus the normal mass building routine. I use a single rep set occasionally at the end or a workout for a muscle group.

8. Pre-Exhaustion: An example of pre-exhausting the chest would be to perform two sets of push-ups to failure prior to doing your bench press. I like to schedule pre-exhaustive outlines approximately every four weeks. Use light weight and high reps isolating the same muscle group you will use on your next exercise.

9. Burn Out Set: A burn out set is similar to a drop set. Perform your normal set group (ex 12-10-6) of an exercise, immediately following the last rep performed drop the weight in half and continue to do as many reps as you can to failure.

IV. The Exercises

Compound versus Isolation exercises: For the sake of simplicity we will assume your body can be worked in two ways, by tackling each muscle individually or by working a group of muscles at once. When we work an individual muscle or a muscle group that acts on a joint in the same manner, it is called an isolation exercise. Examples of isolation exercises for the legs are leg extensions (quadriceps), leg curls (hamstrings), and calf raises. Compound exercises work several muscles or muscle groups at once. Examples of compound exercises for the legs include squats, leg presses, and lunges which work the glutes, hamstrings, and quadriceps as well as a variety of smaller support muscles.

Once again I recommend using a variety of compound and isolation exercises. Sometimes I pre-exhaust my quadriceps with leg extensions making them work extra hard when I perform squats, or I finish my leg presses with hamstring curls to really make sure I got everything out of them. Alternate between isolation and compound exercises but remember the large compound movements should be the emphasis of your workouts.

Go to Page 1

BIO:

Matt Russ has coached and trained athletes around the country and internationally. He currently holds licenses by USAT, USATF, and is an Expert level USAC coach. Matt has coached athletes for CTS (Carmichael Training Systems), is an Ultrafit Associate. Visit www.thesportfactory.com for more information.

Some Aditional Articles you may enjoy

Helen's Rustic Mash Potato Recipe by Helen Porter

The Utopia of Now by Julia Allworth

Know Your Bodybuilding Supplement - Ecdysterone by Rick Mitchell

The Health Benefits of Sex by Susie Michelle Cortright

Low-Carb Diets: Are You Losing More than Weight? by Monique N. Gilbert, B.Sc.

Click a Number to go to an article index page
1 | 2 | 3 | 4 | 5 | 6 | 7 | 8 | 9 | 10 | 11 | 12 | 13 | 14 | 15 | 16 | 17 | 18 | 19 | 20 | 21 | 22 | 23 | 24 | 25 | 26 | 27 | 28 | 29 | 30 | 31 | 32 | 33 | 34 | 35 | 36 | 37 | 38 | 39